INDUSTRIAL SECTIONAL DOOR "SLX 40"

• Masonry
• Concrete
• Steel structures

Width:   2000 - 4000 mm
Height:  1875 - 6000 mm
(more dimensions on requets)

• Frame construction made of aluminium profiles; cold-rolled section without thermal separation: AL-MG-SI 0.5
• Anodised E6/EV1 surface, filled as standard with 19 mm synthetic double glazing, colourless, scratch-resistant
• Synthetic holding strip black, with seal
• Additional filling with triple glazing
• The doors are available without vertical mullions up to a width of 3,000 mm – above 3,000 mm they are fitted with a vertical mullion

• Shaft drive, chain drive, three-phase voltage 400V 3~Ph, 50 Hz, 20 cycles per hour, protection class IP 65, with emergency hand crank, TÜV approved
• Shaft drive with alternating voltage 230 Volt 1~Ph, 50 Hz, 20 cycles per hour, protection cl. IP 65, with emergeny hand crank, TÜV approved, combined with a frequency converter control with “soft”-start and “soft” stop
• Direct drive as springless door without weight compensation, three-phase voltage 400V 3~Ph, 50Hz, 20 cycles per hour, protection class IP 65, with emergency hand crank, TÜV approved, safety device integrated

• For shaft and chain drives, ready to plug pre-wired and with CEE-plug. In the basic usage noticed as deadman-control. Function without closing edge safety device, control voltage 24V safety extra low voltage, protection class IP 65, push buttons open-stop-close
• Pulse control (automatic mode “close“) in connection with closing edge safety device
• Radio remote control
• Automatic closing in combination with traffic lights
• Traffic control

• Casing
• Fixed panels
• Matching side door N53 with upper casing
• Stop rail
• Ventilation grille
• Special RAL-colours